WinCC/SES offers easy changing of production parameters and production processes in Runtime without changing the PLC code.

Clear visualization of the production steps with the latest states.

Option for targeted intervention in the running process with manual jumps to a specific step or with automatic jumps as soon as a configured event occurs

Clearly structured comparison of actual values with setpoints for each individual step

Single-step mode in which the operator can switch to the next step independently.

WinCC/SES is especially suitable for production plants in which dosing, mixing and material transport are important process actions. 

SIMATIC WinCC/SES V7.5 offers convenient configuration in the Configuration Studio

You can now keep multiple SES controls open at the same time.

SES V7.5 now gives you the option to define up to 200 steps in a sequence.

Control of up to 160 control elements per unit.

Up to 1000 parameters per sequence are now supported

SES V7.5 now supports up to 150 units.

Simultaneous saving of up to 5 sequences per unit in the PLC.

Exception handling (special sequences) is supported, which can be activated as soon as the Running state is changed to Holding, Resuming, Aborting, etc.

Note that SIMATIC WinCC/SES requires SIMATIC WinCC V7.5 as a basis.

WinCC/SES supplements SIMATIC WinCC V7.5 with the functions mentioned above.

In regard to configuration, WinCC/SES V7.5 has been released for the WinCC V7.5 operating system platforms

Configuration and Runtime are supported in the single-user system.

Configuration and Runtime are supported as follows in the multi-user system: